@DIG78x wrote:

Few questions:

How do I know which change to make, needle clip vs float height?

Maybe a silly question, but is the top nut that attaches to the carb cap supposed to be tight? This has the throttle cable within it.

Is there an optimal cylinder head temp that I should be aiming for?

Lastly, this past weekend I tried putting the needle clip to the 5th position (richest), and couldn’t even get the kart to idle for some reason. Even with the idle screw all the way in, and the air mixture screw all the way out (or in, tried both), it would die immediately after letting off the throttle (on the stand), and ran terribly even with a little throttle. What might be the cause of that?

I am in Briggs LO206 senior.

Posts: 1

Participants: 1

Read full topic

Powered by WPeMatico